Noco Genius G1100AU Smart Charger 12V & 6V 1.1A 1100mA

Noco

G1100AU

 

G1100 TECHNICAL SPECIFICATIONS

Input Voltage AC 220-240 VAC, 50-60Hz
Working Voltage AC 220-240 VAC, 50-60Hz
Input Current 600mA RMS Max
Efficiency 85% Approx.
Power 30W Max
Charging Voltage 7.2/14.4, 7.4/14.7V (Cold/AGM)
Charging Current 1100mA
Back Current Drain <5mA
Ripple <2%
Ambient Temperature 0°C to +40°C
Charger Type 7 Step, Fully Automatic,
Switch-Mode
Type of Batteries 6V & 12V Lead-Acid
Battery Chemistries Wet, Gel, MF & AGM
Battery Capacity 2.2-40Ah,
Maintains All Battery Sizes
Housing Protection IP65
Cooling Natural Convection
Noise Level <50dB
Dimensions (L x W x H) 6.1 x 2.5 x 1.6 Inches
Weight 0.8 Pounds
WHAT'S IN THE BOX
  • G1100 Charger
  • Battery Clamp Connectors
  • Eyelet Terminal Connectors
  • Owner's Manual & User Guide
CHARGING TIMES
The time required for the G1100 to charge a normally discharged battery is shown below. Deeply discharged batteries may take longer to charge depending on the depth of discharge (DOD). The charge time is based on an average depth of discharge to a fully charged battery.

Note: The above table is for reference purposes only. Actual data may differ due to battery conditions. The time required for the G1100 to charge a normally discharged battery is based on an average DOD of 50%.


CHARGING STEPS

Step 1: Diagnostics
Checks the battery voltage to make sure battery connections are good and the battery is in a stable condition before beginning the charge process.

Step 2: Recovery
Initializes the Recovery process, if needed, for deeply discharged or sulfated (desulfation) batteries by pulsing small amounts of current.

Step 3: Soft Start
Begins Bulk charging process with a gentle (soft) charge.

Step 4: Bulk
The Bulk charging process continues and returns 80% of the battery capacity. Indicated by the 25%, 50% and 75% CHARGE LEDs.

Step 5: Absorption
Brings the charge level to 90%. The battery charger will deliver small amounts of current to provide a safe, efficient charge and limit battery gassing.

Step 6: Trickle
Battery is fully charged and ready to use, indicated by the 100% CHARGE LED being a solid Green. In this step, the battery charger will only deliver enough current that the battery needs. If the battery tells the charger that more current is needed, the battery charger will switch to Maintenance.

Step 7: Maintenance
Continuously monitors the battery voltage to determine if a maintenance charge should be initiated. If the terminal voltage falls below 6.4V (6V) and 12.8V (12V), the charger will start the Maintenance cycle until voltage reaches 7.2V (6V) and 14.4V (12V) and then discontinues the charge cycle. The cycle between Trickle and Maintenance is repeated indefinitely to keep the battery at full charge, without overcharging. The battery charger can be left connected indefinitely.

Collections: Chargers & Jump Packs

Type: Charger


Related Items